Duratrax Evader BX
As I was getting Duratrax
Evader BX buggy ready for "Make a RC Wish", I set it down next to a
RC10B4. I noticed that the BX was longer than the B4! So I cut the
chassis into two parts, removed 7/8 inch of chassis, then epoxy/bolted
some .040 aluminum parts in place.
Mod a
piece of .040 lexan to the battery in place.
Very surprised by how powerful the Trinity P2K motor is with a 3250
lipo battery.
Duratrax Evader BX
Removed 7/8 inch from
chassis, here is a look at the interal bracing. Epoxy and bolts and the
.040 lexan battery mount.
Bottom showing the cut line
in chassis
BOLT on wing mount. Yes, it's
a OLD B4 wing!!
=========================================
SETUP (OUTDOOR RED CLAY)
Front
Shock Top = middle hole
Arm = inner hole
Kingpin = 2 washer
Link at shock tower = outer hole
Camber = -1
Toe = 0
Shock Oil = 30
Shock Spring = AE buggy black
Arms = just below level
Rear
Shock Top = outside bottom hole
Arm = inside hole
Hub = inside hole
Link at shock tower = outside outer hole
Link at shock tower = inner bottom
Camber = -1
Shock Oil = 30
Shock Spring = AE Green
Dog Bones = level
Wheel Base = long
Track
Surface = Smooth to bumpy as more Qual's/mains ran
Traction = Med to low as track dry's
Type = Red Clay
Condition = Wet / Jumps Drying
Battery Placement = No spacers
|
|
 |
|
